solar street lights have become the most commonly used road lighting construction in rural areas. Today, solar street lights manufacturers count 8 common installation errors for everyone.
01 There are too many obstructions in the installation place. Installed at leaves, buildings or other obstructions to block the light, resulting in a decrease in the charging efficiency of the Solar Panel. Affect the absorption and utilization of light energy.
02 There is a reference light source next to the solar panel. For example: there is another street lamp next to the Solar Street Light. When night falls, the next street light is on. The solar panel detects the light source and mistakenly believes it is daytime. At this time, the controller will not let it turn on. As a result, the charging voltage of the solar panel is above the light control voltage point and the light cannot be turned on.
03 Solar panels are installed under the shelter. Solar panels usually have multiple strings. If there is a shadow on a string of solar panels during the day, the shadow is relatively deep. If it is serious, this string is equivalent to a circuit break. And if this solar panel is multi-string and 1 parallel, this solar panel will not generate electricity.
04 Solar panels are tilted face-to-face. Solar panels are installed face-to-face and tilted symmetrically, but if one side is oriented correctly, then the other side is definitely wrong. On the wrong side, since the solar panels are not directly exposed to the sun, the charging efficiency will be reduced.
05 Solar panel angle adjustment is incorrect. The correct solar panel angle adjustment should follow a simple principle: let the sun shine directly on the solar panel, so that the charging efficiency is maximized. In different places, you can refer to the local longitude and latitude to adjust the angle of the solar panel. The solar panel can be tilted horizontally as much as the latitude and longitude. For different latitudes and different roads, the adjustment of the solar panel angle is quite critical.
06 Solar panels are charged indoors. Solar street lights are installed in the shed to facilitate the use of the shed at night, but the solar panels are also installed in the shed, so the charging effect will be severely limited. In this case, we can charge outdoors and discharge indoors. The solar panel is installed separately from the lamp.
07 Freely extend the solar panel connection line. In some locations, because the installation of solar panels interferes too much, the solar panel and the lamp are separated by a long distance, and some need to be separated by a distance of 10 meters or more, and then you can buy two on the market. That`s what happened when the core wires were connected. The quality of the general wires on the market is not very good, and the distance between the wires is very long, and the wire loss is large, so the charging efficiency will be reduced, and the lighting time will be affected.
08 On-site personnel incorrectly used the engineering remote control. According to many on-site understandings, some construction personnel reported that they did not know the function and purpose of the remote control. The parameter setting error caused the light to not turn on. After all, I pressed it randomly, and it didn't matter if the light was on. In fact, the parameters may have been set incorrectly at this time, resulting in abnormal lighting.
Previous: Why do LED solar street lights use lithium batteries?
Next: Why are solar street lights so hot?
